ASTM A153 / F2329: Zinc Coating (Hot-Dip) on Iron and Steel Hardware, and on Threaded Fasteners
The hot-dip galvanizing standards for hardware. F2329 was written specifically for threaded fasteners; A153 covers hardware in general.
What it covers
- Hot-dip zinc coating on bolts, nuts, washers and small hardware
- Coating weight and thickness by item class
- Thread allowances and testing
| Class | Applies to | Average thickness | Minimum single specimen |
|---|---|---|---|
| C | Fasteners over 3/8 in. (9.5 mm) diameter | 2.1 mils (53 µm) | 1.7 mils (43 µm) |
| D | Fasteners 3/8 in. diameter and under | 1.7 mils (43 µm) | 1.4 mils (36 µm) |
Notes for specifiers
- Thickness on bolts, nuts and screws is measured on a part of the article that does not include threads.
- Galvanized nuts are overtapped so they assemble with coated bolts. Always galvanize bolt-and-nut sets together, not one or the other.
- F2329 is the more fastener-appropriate specification and supersedes reliance on A153 Class C for fasteners.
- High-strength steel needs caution: A490 / BD-class bolts should not be hot-dip galvanized, and Grade 105 rods need a procedure check.
- Fabricated items such as base plates are galvanized to ASTM A123, which has thickness requirements by steel thickness.
Example specification wording
Galvanizing: hot-dip zinc coating to ASTM F2329 on all bolts, nuts and washers. Nuts overtapped after coating allowance. Fabricated plates to ASTM A123.
Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.