Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ASTM F1554

Anchor Bolts, Steel, 36, 55 and 105 ksi Yield Strength

ASTM F1554: Anchor Bolts, Steel, 36, 55 and 105 ksi Yield Strength

The governing standard for anchor bolts and anchor rods in steel-to-concrete connections, in three grades defined by yield strength.

What it covers

  • Headed, bent and straight anchor bolts and rods
  • Grades 36, 55 and 105 (yield in ksi)
  • Diameters 1/4 in. to 4 in. (Grade 105 to 3 in.)
  • Plain, galvanized or other coatings as specified

Mechanical requirements

GradeSizeTensile (min – max)Yield (min)Elong. % minRA % minNotes
Grade 361/4 – 4 in.400 – 552 MPa58 – 80 ksi248 MPa36 ksi2340Blue end marking. Most common. Weldable.
Grade 551/4 – 4 in.517 – 655 MPa75 – 95 ksi379 MPa55 ksi2130Yellow end marking. Weldable with Supplementary Requirement S1.
Grade 1051/4 – 3 in.862 – 1034 MPa125 – 150 ksi724 MPa105 ksi1545Red end marking. High strength: not for welding.

F1554 is an inch-pound standard. Metric values are direct conversions, not values published by ASTM.

Matching hardware and finishing

Nut, Grade 36
ASTM A563 Grade A (hex or heavy hex)
Nut, Grade 55
ASTM A563 Grade A heavy hex (Grade B or C where specified)
Nut, Grade 105
ASTM A563 Grade DH heavy hex
Washer
ASTM F436 hardened, or plate washers per the drawing
Galvanizing
ASTM F2329 / A153 for the rod; nuts overtapped

Notes for specifiers

  • Grade 36 replaced ASTM A307 Grade C for structural anchor bolts in 2007; the Grade 36 requirements match it, with a 40 % reduction-of-area requirement added.
  • Thread series: anchor rods are commonly supplied coarse (UNC) to 1 in. and 8-UN above 1 in., Class 2A. State the series on the order rather than relying on the default.
  • Check the standard's substitution clause. Material supplied as Grade 55 can fill a Grade 36 order; say so on the drawing if weldability or ductility assumptions matter.
  • Grade 105 is a high-strength steel. Ask about hardness limits and the galvanizing procedure before specifying a hot-dip coating.
  • Embedment, edge distance and concrete breakout are design checks under ACI 318 Chapter 17 or AISC Design Guide 1, not requirements of F1554.

Example specification wording

Anchor rods: ASTM F1554 Grade 55, Supplementary Requirement S1, ASME B1.1 Class 2A threads (UNC to 1 in., 8-UN above), hot-dip galvanized to ASTM F2329. Nuts: ASTM A563 Grade A heavy hex, galvanized and overtapped. Washers: plate washers per the drawing.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.