Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ASTM F3125

High Strength Structural Bolts, Steel and Alloy Steel, 120 ksi and 150 ksi Minimum Tensile Strength

ASTM F3125: High Strength Structural Bolts, Steel and Alloy Steel, 120 ksi and 150 ksi Minimum Tensile Strength

The consolidated structural bolt standard. It replaced A325, A490, F1852 and F2280, which are now Grades within F3125.

What it covers

  • Grade A325 (120 / 105 ksi) and Grade A490 (150 ksi) heavy hex structural bolts
  • Grades F1852 and F2280: twist-off (tension control) bolts
  • Inch (A325, A490) and metric (A325M, A490M) versions
  • Type 1 (carbon / alloy) and Type 3 (weathering)

Mechanical requirements (inch grades)

GradeSizeTensile (min – max)Yield (min)Elong. % minRA % minHardnessNotes
A3251/2 – 1 in.827 MPa120 ksi634 MPa92 ksi1435HRC 25 – 34
A3251-1/8 – 1-1/2 in.724 MPa105 ksi558 MPa81 ksi1435
A4901/2 – 1-1/2 in.1034 – 1193 MPa150 – 173 ksi896 MPa130 ksi1440HRC 33 – 38Not for hot-dip galvanizing.

SI values shown are direct conversions of the inch grades. The metric grades A325M and A490M are separate grades with their own published values.

Matching hardware and finishing

Nut
ASTM A563 Grade DH (A325 may also use C or C3)
Washer
ASTM F436 hardened
Tension indication
ASTM F959 DTI washers, or twist-off bolts (F1852 / F2280)
Galvanizing
A325 only; nuts overtapped and lubricated

Notes for specifiers

  • A490 bolts must not be hot-dip galvanized: their strength makes them susceptible to hydrogen embrittlement. Use a different coating or a different grade.
  • Pretension is installed by turn-of-nut, calibrated wrench, twist-off bolts or DTI washers, as the connection type requires (RCSC Specification). Torque alone is a poor proxy for tension.
  • Hardness limits shown are the current F3125 values for full-size bolts; the withdrawn A325 / A490 standards listed slightly different ranges.
  • Metric A325M (8.8-equivalent) and A490M (10.9-equivalent) are separate grades; do not substitute ISO 898-1 bolts for them without checking the joint design.
  • Specify Type 3 for weathering-steel structures so the bolt weathers like the member.

Example specification wording

Structural bolts: ASTM F3125 Grade A325 Type 1 heavy hex, hot-dip galvanized to ASTM F2329. Nuts: ASTM A563 Grade DH, galvanized, overtapped and lubricated. Washers: ASTM F436. Installation per the RCSC Specification.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.