Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ISO 898-1

Mechanical Properties of Fasteners Made of Carbon Steel and Alloy Steel: Bolts, Screws and Studs with Specified Property Classes

ISO 898-1: Mechanical Properties of Fasteners Made of Carbon Steel and Alloy Steel: Bolts, Screws and Studs with Specified Property Classes

The metric property-class system. The two numbers in "8.8" tell you the strength: 8 × 100 = 800 MPa tensile, and 0.8 of that is the yield.

What it covers

  • Property classes 4.6 to 12.9
  • Coarse and fine metric threads
  • Sizes M1.6 to M39 (larger by agreement)

Minimum mechanical properties (tensile Rm, yield Rp0.2 or ReL)

GradeSizeTensile (min)Yield (min)Elong. % min
4.6400 MPa58 ksi240 MPa35 ksi22
4.8420 MPa61 ksi340 MPa49 ksi14
5.6500 MPa73 ksi300 MPa44 ksi20
5.8520 MPa75 ksi420 MPa61 ksi10
6.8600 MPa87 ksi480 MPa70 ksi8
8.8M16 and under800 MPa116 ksi640 MPa93 ksi12
8.8over M16830 MPa120 ksi660 MPa96 ksi12
9.8M16 and under900 MPa131 ksi720 MPa104 ksi10
10.91,040 MPa151 ksi940 MPa136 ksi9
12.91,220 MPa177 ksi1,100 MPa160 ksi8

ISO publishes SI values only. The inch-pound figures are conversions.

Matching hardware and finishing

Nut
ISO 898-2 class 8 / 10 / 12 for 8.8 / 10.9 / 12.9
Washer
ISO 7089 / 7090, hardened 300 HV for 10.9 and up
Galvanizing
ISO 10684 (not for 10.9 / 12.9 without precautions)

Notes for specifiers

  • How to read the code: the first number × 100 is the minimum tensile strength in MPa; the second × 10 is the yield as a percentage of tensile. So 10.9 means 1000 MPa nominal tensile and 90 % yield ratio.
  • The 8.8 minimums in some editions differ by size band, as shown. Use the figures from the edition your project cites.
  • The nearest ASTM equivalents are not identical: 8.8 is close to A325M; 10.9 is close to A490M.
  • Classes 10.9 and above are susceptible to hydrogen embrittlement; avoid hot-dip galvanizing them.

Example specification wording

Bolts: ISO 4014 hex head, property class 8.8, EN ISO 898-1, hot-dip galvanized to EN ISO 10684. Nuts: ISO 4032 class 8. Washers: ISO 7089 200 HV.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.