Metric specifications
The metric path: ISO and EN standards, property classes, ISO metric threads and the calculators set to millimetres, MPa and kN.
5 ISO and EN standards
Dimensions in millimetres, strength in MPa, force in kN, torque in N·m.
Nuts
- ISO 898-2 Mechanical Properties of Fasteners: Nuts with Specified Property Classes
Bolts & rods
- ISO 898-1 Mechanical Properties of Fasteners Made of Carbon Steel and Alloy Steel: Bolts, Screws and Studs with Specified Property Classes
- ISO 3506-1 Corrosion-Resistant Stainless Steel Fasteners: Bolts, Screws and Studs
- EN 14399 / 15048 High-Strength Structural Bolting Assemblies for Preloading (EN 14399) and Non-Preloaded Structural Bolting (EN 15048)
Dimensions & threads
- ISO 4014 / 4032 / 7089 Metric Hexagon Head Bolts (4014), Hexagon Nuts (4032) and Plain Washers (7089)
Set to this path's units
All calculators work in both systems. Typed values carry across when you switch.
Bolt weight calculator
Weights of bolts, nuts and washers with a running order tally. Inch or metric.
OpenCalculatorsPlate weight calculator
Square or round plate with an optional hole.
OpenCalculatorsTie rod calculator
Rod length to order from a pin-to-pin dimension, with clevis and turnbuckle allowances.
OpenCalculatorsUnit converter
Length (with fractions), force, stress, torque, mass and area between inch-pound and SI.
OpenCalculatorsBolt strength calculator (AISC 360 / Eurocode 3)
Tension and shear resistance per bolt, LRFD or ASD, with the tension-shear interaction check; or EN 1993-1-8 for metric bolts.
OpenCalculatorsAnchor rod steel strength (ACI 318)
Steel tension and shear strength of cast-in anchors by grade, with the ductility check. Concrete failure modes are not covered.
OpenCalculatorsTorque and preload calculator
Target preload and installation torque from T = K·D·P for any bolt grade and nut factor.
OpenCalculatorsBolt length (grip) calculator
Length to order from the grip, washers, nut and thread projection, rounded up to stock.
OpenCalculatorsSpecification selector
Choose the bolt, nut, washer and coating specification for an application, with example specification wording.
OpenTables and charts
Need a specification checked?
Send the clause, the drawing note or the datasheet. We will tell you what it asks for and what it would cost to supply.