Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Reference data

Thread data

Pitch, pitch diameter, minor diameter and tensile stress area for the unified inch series and the ISO metric series. The stress area is what strength calculations use.

Thread data

ThreadPitchPitch dia. (mm)Minor dia. (mm)Stress area (mm²)
M6 × 11 mm5.354.7720.1
M8 × 1.251.25 mm7.196.4736.6
M10 × 1.51.5 mm9.038.1658
M12 × 1.751.75 mm10.869.8584.3
M14 × 22 mm12.711.55115
M16 × 22 mm14.713.55157
M18 × 2.52.5 mm16.3814.93192
M20 × 2.52.5 mm18.3816.93245
M22 × 2.52.5 mm20.3818.93303
M24 × 33 mm22.0520.32353
M27 × 33 mm25.0523.32459
M30 × 3.53.5 mm27.7325.71561
M33 × 3.53.5 mm30.7328.71694
M36 × 44 mm33.431.09817
M39 × 44 mm36.434.09976
M42 × 4.54.5 mm39.0836.481121
M45 × 4.54.5 mm42.0839.481306
M48 × 55 mm44.7541.871473
M52 × 55 mm48.7545.871758
M56 × 5.55.5 mm52.4349.252030
M60 × 5.55.5 mm56.4353.252362
M64 × 66 mm60.156.642676

Computed from the basic thread forms: inch pitch dia. = D − 0.6495/n and stress area = 0.7854 (D − 0.9743/n)²; metric pitch dia. = D − 0.6495P and stress area = (π/4)(D − 0.9382P)². Sizes above 2 in. use the 4-UN series that large anchor rods commonly use. Inch series are inch parts and metric series are ISO parts: they do not interchange.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Ready to get a quotation?

Build a list of products and quantities, or send a sketch or a drawing. Our sales team replies with a quotation.