Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Dimensions & threads

ASME B1.1

Unified Inch Screw Threads (UN and UNR Thread Form)

Ask an engineer

ASME B1.1: Unified Inch Screw Threads (UN and UNR Thread Form)

The inch thread standard: UNC, UNF and constant-pitch series such as 8-UN, with the tolerance classes that decide how nuts and bolts fit.

What it covers

  • Coarse (UNC), fine (UNF) and constant-pitch (4-UN, 6-UN, 8-UN, 12-UN) series
  • Tolerance classes 1A / 2A / 3A (external) and 1B / 2B / 3B (internal)

Notes for specifiers

  • Class 2A / 2B is the general-purpose fit. Class 2A external threads carry an allowance, which is what leaves room for a zinc coating.
  • Galvanized bolts are not made with undersized threads; the nut is tapped oversize instead (see A563).
  • For anchor rods and flange bolting above 1 in., 8-UN is the common constant-pitch choice; large coarse threads get very steep.
  • The thread data chart gives pitch diameter, minor diameter and tensile stress area for each series.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.