Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ASTM A307

Carbon Steel Bolts, Studs and Threaded Rod, 60,000 psi Tensile Strength

ASTM A307: Carbon Steel Bolts, Studs and Threaded Rod, 60,000 psi Tensile Strength

The general-purpose low-carbon bolt: 60 ksi minimum tensile, no minimum yield, used where loads are modest and pretension is not required.

What it covers

  • Hex and square head bolts, studs and threaded rod
  • Grade A (general applications), Grade B (flanged piping)
  • Sizes from 1/4 in. through 4 in.

Mechanical requirements

GradeTensile (min – max)Notes
Grade A414 MPa60 ksiNo minimum yield is specified.
Grade B414 – 689 MPa60 – 100 ksiLower-strength companion for cast-iron flanges.

Metric values are direct conversions.

Matching hardware and finishing

Nut
ASTM A563 Grade A
Washer
ASTM F844 or ASME B18.22.1 plain washer

Notes for specifiers

  • A307 bolts are not pretensioned. For slip-critical or pretensioned joints use F3125 (A325 / A490).
  • AISC treats A307 as the lowest-strength structural bolt; its design stresses are much lower than A325 for the same diameter.
  • Grade C, formerly used for anchor bolts, has been replaced by ASTM F1554 Grade 36.
  • Because there is no minimum yield, do not use A307 where a yield-based check (for example ACI 318 anchor design) is required.

Example specification wording

Bolts: ASTM A307 Grade A hex head, hot-dip galvanized to ASTM F2329. Nuts: ASTM A563 Grade A, galvanized and overtapped.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.