Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ASTM A449

Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength

ASTM A449: Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength

A quenched-and-tempered carbon-steel bolt with A325 strength that is available in custom lengths, threads and diameters up to 3 in.

What it covers

  • Bolts, studs and U-bolts to 3 in. diameter
  • Three strength levels by diameter
  • Not intended for pretensioned structural joints

Mechanical requirements

GradeSizeTensile (min)Yield (min)Elong. % min
Type 11/4 – 1 in.827 MPa120 ksi634 MPa92 ksi14
Type 11-1/8 – 1-1/2 in.724 MPa105 ksi558 MPa81 ksi14
Type 11-3/4 – 3 in.621 MPa90 ksi400 MPa58 ksi14

Metric values are direct conversions.

Matching hardware and finishing

Nut
ASTM A563 Grade C or DH (DH for larger sizes)
Washer
ASTM F436 hardened

Notes for specifiers

  • A449 is the usual choice when A325 strength is wanted but the diameter, thread length or form is outside what F3125 covers, such as large-diameter rods and U-bolts.
  • It carries no pretension or slip-critical provisions; do not use it as a substitute for F3125 in a structural joint that requires them.
  • Strength steps down as diameter rises, so check the size band, not just the grade.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.