Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

ASTM A320 / A320M

Alloy-Steel and Stainless Steel Bolting for Low-Temperature Service

Ask an engineer

ASTM A320 / A320M: Alloy-Steel and Stainless Steel Bolting for Low-Temperature Service

Bolting that is impact-tested so it stays tough in the cold. Grade L7 is the alloy-steel equivalent of B7 with Charpy testing.

What it covers

  • Grades L7, L7M, L43 (alloy) and the B8 stainless family
  • Charpy V-notch impact testing at low temperature
  • Inch and metric versions

Mechanical requirements (L7, to 2-1/2 in.)

GradeSizeTensile (min)Yield (min)Elong. % minRA % minNotes
L7to 2-1/2 in.860 MPa125 ksi720 MPa105 ksi1650Charpy V-notch: 20 ft·lbf (27 J) at −150 °F (−101 °C).

Matching hardware and finishing

Nut
ASTM A194 Grade 4 or 7, impact tested

Notes for specifiers

  • Low-temperature performance is the point: specify the impact temperature on the order if the project needs a different one.
  • Hot-dip galvanizing is possible but the procedure should be agreed because it can affect toughness.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.