Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Bolts & rods

SAE J429 / J995

Mechanical and Material Requirements for Externally Threaded Fasteners (J429) and Nuts (J995)

Ask an engineer

SAE J429 / J995: Mechanical and Material Requirements for Externally Threaded Fasteners (J429) and Nuts (J995)

The SAE grades 2, 5 and 8 that identify bolts by the radial lines on the head, widely used in machinery and general engineering.

What it covers

  • Grades 2, 5 and 8 bolts and screws, 1/4 – 1-1/2 in.
  • Matching nut grades in J995

Mechanical requirements

GradeSizeTensile (min)Yield (min)ProofElong. % minNotes
Grade 2to 3/4 in.510 MPa74 ksi393 MPa57 ksi379 MPa55 ksi18No head marks.
Grade 27/8 – 1-1/2 in.414 MPa60 ksi248 MPa36 ksi228 MPa33 ksi18No head marks.
Grade 5to 1 in.827 MPa120 ksi634 MPa92 ksi586 MPa85 ksi14Three radial lines.
Grade 51-1/8 – 1-1/2 in.724 MPa105 ksi558 MPa81 ksi510 MPa74 ksi14Three radial lines.
Grade 81/4 – 1-1/2 in.1,034 MPa150 ksi896 MPa130 ksi827 MPa120 ksi12Six radial lines.

Metric values are direct conversions.

Matching hardware and finishing

Grade 5 nut
SAE J995 Grade 5
Grade 8 nut
SAE J995 Grade 8

Notes for specifiers

  • SAE grades are not interchangeable with ASTM structural grades in code-governed construction. Use F3125 for structural bolts.
  • Head markings identify the grade; the manufacturer's mark must also be present.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Specifying this and want it checked?

Send the clause or the drawing note. We will confirm what it requires and whether we can supply it.