Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Designers, specifiers and fabricators

Galvanizing fasteners: what designers need to know

Which standards apply, why nuts are overtapped, and which high-strength steels should not be hot-dip galvanized.

Which standard applies

  • ASTM F2329: hot-dip zinc coating on threaded fasteners. The fastener-specific standard.
  • ASTM A153: hot-dip zinc coating on iron and steel hardware. For fasteners it sets Class C (over 3/8 in., 2.1 mil / 53 µm average) and Class D (3/8 in. and under, 1.7 mil / 43 µm average).
  • ASTM A123: fabricated products such as base plates, where required thickness depends on the steel thickness.
  • ISO 10684 covers fasteners and ISO 1461 fabricated articles outside North America.

How threads are handled

The coating adds thickness to external threads, so the nut is tapped oversize before coating to run onto them. This is why galvanized nuts and bolts should be ordered together as a matched set, and why a plain nut on a galvanized bolt does not give the engagement the standard assumes.

Coating thickness on fasteners is measured on a part of the article without threads.

Strength limits

  • ASTM A490 and other very high-strength bolts (and ISO property classes 10.9 and 12.9) can suffer hydrogen embrittlement. Do not hot-dip galvanize them without taking the precautions the standard describes; the usual advice is to choose another coating or a lower grade.
  • F1554 Grade 105 and A354 BD are high strength: agree a hardness limit and galvanizing procedure before specifying.
  • A325 bolts are routinely galvanized, with overtapped, lubricated nuts.

Weathering steel and mixed metals

  • Weathering-steel joints use Type 3 bolts, which are not galvanized, so the bolt weathers with the member.
  • Stainless steel in contact with galvanized or carbon steel in wet conditions forms a galvanic couple; isolate the metals or design the detail to stay dry.

Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.

Ready to get a quotation?

Build a list of products and quantities, or send a sketch or a drawing. Our sales team replies with a quotation.