They are different parts, not different units
A 1/2 in. bolt is 12.7 mm; an M12 bolt is 12 mm with a different thread pitch. They do not interchange, and a nut from one will not run on the other. Converting a size in millimetres is fine for communication; it does not turn one fastener into the other.
This site shows inch-series parts in either unit system. Metric-series parts (ISO M-sizes and property classes) are listed separately and chosen explicitly when you add an item to an enquiry.
Comparing strength classes
- ASTM A325 (120 ksi tensile, 827 MPa) is close to ISO class 8.8 (800 – 830 MPa), but yield and design rules differ.
- ASTM A490 (150 ksi, 1,034 MPa) is close to ISO class 10.9 (1,040 MPa).
- Close is not identical. Substituting one for the other needs the engineer of record to confirm, because the design provisions (AISC 360 versus EN 1993-1-8) treat them differently.
- Nuts follow the same logic: ASTM A563 Grade DH versus ISO 898-2 class 10 or 12.
Holes, washers and paperwork
- Standard bolt holes are the bolt diameter + 1/16 in. in AISC practice; EN 1090-2 uses a 1 – 3 mm clearance by size. See the bolt hole size chart.
- US mill test reports and European inspection certificates (EN 10204, type 3.1) serve a similar purpose but are not identical documents. Say which the project requires.
What to put on an international enquiry
- The governing standard (ASTM, ISO or EN) and the grade or property class.
- Thread series and pitch for metric parts.
- Both unit systems for every dimension. The enquiry list on this site records both automatically.
Prepared from the published tables of the standards named and cross-checked against secondary references. It is a working reference, not a substitute for the standard: confirm against the current edition before using it in design, specification or procurement.