Technical resources: 26 standards · 9 calculators · metric & imperial
Contact
Standards, calculators and data for designers, consultants and specifiers

Technical resources

Specifications, material data, design calculators and reference tables for anchor bolts and construction fasteners. Choose a specification path below, or search everything.

  • 26 standards
  • 7 materials
  • 9 calculators
  • 13 reference tables
  • 3 guides
Standards

26 standards, one template

Each page gives the grades and their properties, the matching nut and washer, coating notes, what to write in a specification, and the cross-references.

All standards

Reference data

Tables and charts

ISO metric threadsCoarse and fine series M6 to M64: pitch, pitch and minor diameters, stress area, tap drill.Thread data: UNC, UNF, 8-UN and ISO metricPitch, pitch diameter, minor diameter and tensile stress area for inch and metric thread series.Strength requirements by gradeTensile, yield and proof strength for ASTM, SAE and ISO grades, in ksi and MPa.Bolt load tableMinimum tensile and yield loads by size and grade, computed from the stress area.Bolt hole sizesStandard, oversized and slotted holes per AISC 360 Table J3.3, and nominal clearances per EN 1090-2.Nut compatibilityWhich nut grade and style goes with which bolt.Structural bolt pretension and torqueAISC minimum pretension for A325 and A490 and the torque estimate for a chosen nut factor.Structural bolt weightsWeight per 100 heavy hex structural bolts by diameter and length.Nut weightsWeight per 100 hex, heavy hex, jam and square nuts.Rod weight chartWeight per foot and per metre of plain round steel rod, inch and metric sizes.Rebar sizesUS bar sizes with diameter, area and weight, beside the soft-metric designations.Inch, fraction and millimetre chartSixteenths and thirty-seconds of an inch to decimal inches and millimetres.AASHTO to ASTM conversionsCross-reference between highway and ASTM specifications.Fastener identification markingsHow to read the grade stamped on a bolt head.Frequently asked questionsAnswered questions on threads, galvanizing, anchor bolts, nuts and ordering.GlossaryPlain-English definitions of fastener terms.

This is a working reference prepared from published standards and cross-checked against secondary sources. Confirm against the current edition of the governing standard before relying on it in design or procurement. Calculators are design aids, not a substitute for the engineer of record.

Need a specification checked?

Send the clause, the drawing note or the datasheet. We will tell you what it asks for and what it would cost to supply.